Mitutoyo Surftest Sv400 User Manual Full !new!

Before performing any certified measurement, the SV-400 must be calibrated against a traceable roughness specimen (typically an Racap R sub a reference patch). Step-by-Step Calibration Procedure

Review the measured value. If it falls outside the acceptable tolerance (typically

Ensure the stylus and detector are clean before use. For digital calibration and resetting origins, always close the measuring faces with consistent force using the ratchet stop to avoid thermal expansion errors. Downloads - Mitutoyo Europe

0.02 to 5 mm/s during measurement; up to 10 mm/s during positioning. mitutoyo surftest sv400 user manual full

Check for signs of jerky travel movements or sticking along the X-axis carriage line.

If you are encountering any specific ?

Check drive path clearance. Cycle power. Re-seat connection pins. Environmental vibration or loose detector mounting. Tighten detector clamp. Relocate unit to isolation station. Before performing any certified measurement, the SV-400 must

Position the stylus in the center of the specimen's micro-grooves, traveling perpendicular to the grooves.

Which or numerical fault indicator is showing on screen?

Ensure the target measurement line runs perfectly parallel to the X-axis drive unit tracking path. Step 3: Positioning the Stylus For digital calibration and resetting origins, always close

To maintain high accuracy, regular calibration using a certified Mitutoyo precision roughness specimen (reference specimen) is mandatory.

Data can be saved in native software formats, exported as a CSV file for statistical process control (SPC), or printed directly as a graphical report showing both the numeric parameters and the visual material ratio curves. 7. Maintenance and Troubleshooting Routine Maintenance Schedule

Calibration ensures accuracy and must be performed at the start of every shift, or whenever the stylus tip is swapped. Materials Required

In SURFPAK, configure your measurement conditions (see Section 4). Click .