If you can’t access the terminal or the WebGUI, the easiest fix is to take the "brain" (the USB flash drive) to another computer. and remove the Unraid USB boot drive. Plug the USB into your PC or Mac . Navigate to the /config folder on the drive. Delete these two files : network.cfg network-rules.cfg (if it exists).
the USB drive and plug it back into the Unraid server. Boot the server. What Happens After a Network Reset?
Short-press the physical power button on your server chassis. Unraid is configured by default to initiate a clean shutdown when the power button is pressed. unraid reset network settings install
Reset Network to default - General Support - Forums - Unraid
(This maps MAC addresses to specific interface names like eth0, eth1) Step 4: Delete or Rename the Files If you can’t access the terminal or the
Remove the network settings files so Unraid regenerates them upon reboot. rm network.cfg rm network-rules.cfg Use code with caution. Reboot: Type reboot to restart the server.
If you cannot access the web GUI, safely shut down your Unraid server. If you have a monitor and keyboard attached, type poweroff and press . If the server is completely unresponsive, press the physical power button once to trigger a graceful shutdown. Avoid pulling the power cord unless absolutely necessary. Step 2: Access the USB Flash Drive Navigate to the /config folder on the drive
To avoid getting locked out again, consider these simple steps:
Once your server reboots with default settings, it will have a new IP address assigned by your router. To log back into the WebUI, try these methods: