全站搜索
Although the specific pin-by-pin text for the IN518 is often bundled in schematic "zip" files, similar driver ICs in its class (like those found in monitors) typically follow this functional layout: : Main power supply input for the IC. : System ground. ENA / ON/OFF : Enable pin to turn the backlight on or off. : Dimming control (analog or PWM) to adjust brightness. : Over Voltage Protection sense pin. DRAIN / GATE : Connection to the external MOSFET for switching.
Interfacing legacy sensors with modern programmable logic controllers (PLCs). Troubleshooting Tips
You have the SOP-20 variant. Pins 19 and 20 are additional power/ground or test pins. Refer to the manufacturer’s addendum – many are no-connects or must be tied to VSS.
Carefully check for solder bridges between the small pins using a 10x loupe. Inx In518 Ic Pinout Diagram
It is a critical component for managing gray-scale voltages.
LCD backlight driver IC / Synchronous Boost Converter.
If you have the (e.g., V420H1), I can help you find more specific troubleshooting steps for that T-CON board. Although the specific pin-by-pin text for the IN518
The IN518 is a synchronous boost converter designed specifically to drive white LEDs, often acting as a substitute for chips like the AAT1176B, TPS65130, or APW8713. It typically operates from a single Lithium-ion cell (2.7V–5.5V), making it ideal for portable, battery-powered devices.
| Parameter | Value / Information | Notes | | :--- | :--- | :--- | | | DC-DC Converter / Power Management IC (PMIC) | Generates multiple voltages for LCD panels | | Package Type | QFN-40 | 5mm x 5mm, 0.4mm pitch | | Input Voltage (VIN) | +12V DC (typical) | From T-CON board | | Key Output Voltages | VAA: +17.9V VDD: +3.3V VGL: -12.5V VGH: +30.4V VCOM: +7.32V | Generated from the main 12V input | | Control Interface | Enable (EN) and Power Good (PWR_OK) signals | For power sequencing with the main processor | | Protection Features | Overcurrent, Undervoltage, Overtemperature | Prevents damage to the LCD panel | | Sub-Models | IN518-NT02, IN518-RI02, IN518-T02 | Some variants may have specific firmware or minor differences |
Pins to enable or disable the IC (EN or ENABLE). Detailed Pin Function Analysis : Dimming control (analog or PWM) to adjust brightness
3.3V to 15V DC (Supports both low-power microcontrollers and standard industrial rails). Output Current per Channel: Up to 50mA.
This pin provides access to the chip’s internal reference voltage generator. Connecting a small bypass capacitor (usually around 10nF to 100nF) from this pin to ground helps stabilize the internal voltage reference, drastically reducing overall output noise. Pin 5: OUT_B / NC (Secondary Output or No Connect)
The IN518 comes in a QFN-40 package, a small, square chip with 40 pins arranged around its perimeter. Without an official pinout diagram, the following information has been synthesized from real-world repair evidence and discussions.
Check Pin 1 (VIN) for power and Pin 2 (EN) for the turn-on signal. If EN is 0V, the problem is likely the mainboard, not the IN518.