Turn your printer back on. The flashing red lights should be gone, and your printer status should return to "Ready." Step 4: Address the Physical Hardware

What the message means

A pop-up will instruct you to turn off the printer. Turn the printer off, click OK on the prompt, wait 5 seconds, and turn the printer back on. Your counter is now at 0%. Using the WIC Reset Utility (Key Method):

A digital reset only tricks the firmware into believing the ink pads are brand new and dry. It clean the physical ink out of the bottom of your printer. epson l3250 waste ink pad resetter

: Turn the printer off and then back on. The error message should now be cleared. ⚠️ Important Maintenance Note

Resetting the waste ink pad counter does not physically clean or replace the ink pads inside your printer. If your printer is heavily used, the pads will eventually overflow and leak ink onto your desk. Use this resetter when you have physically cleaned, replaced the pads, or are using an external waste ink tank.

Fortunately, this problem does not mean your printer is broken permanently. You can resolve this issue yourself using an Epson L3250 waste ink pad resetter tool. Understanding the Epson L3250 Waste Ink Pad Error Turn your printer back on

Epson programs an internal electronic counter (the Waste Ink Pad Counter) into the printer's firmware. Every time the printer performs a self-cleaning cycle, a specific number of points are added to this counter.

A new window with a long list of technical maintenance options will appear. Scroll down to the section. Select Waste ink pad counter from the list and click OK . Step 4: Reading and Resetting the Value Check the box next to Main pad counter .

Before attempting a reset, you must verify that your printer is suffering from a waste ink pad lockout and not a simple paper jam or connectivity issue. The Epson L3250 Your counter is now at 0%

Yes. Install a . This diverts waste ink into a plastic bottle outside the printer. Once done, you can reset the counter as often as you like without ever worrying about sponge saturation.

Step 1: Choosing a Soft Reset Method (The Resetter Software)

to see the current status (it will likely show 100% or close to it). Check the boxes again and click Initialize