Ap3g2-k9w7-tar.153-3.jbb1.tar Work -

: Denotes an Autonomous image. (In contrast, w8 would be a Lightweight/CAPWAP image for WLC management).

archive download-sw /overwrite tftp://<TFTP_SERVER_IP>/ap3g2-k9w7-tar.153-3.jbb1.tar

and a console connection, often involving the "archive download-sw" command or a manual ROMMON recovery process. Cisco Community TFTP server

: Indicates that this is Autonomous software. (In contrast, k9w8 is for Lightweight/WLC-managed mode). Ap3g2-k9w7-tar.153-3.jbb1.tar WORK

This image is commonly used to "convert" a controller-based (Lightweight) AP into a standalone (Autonomous) one. Common Installation Methods AP 3702i - IOS version for Autonomous Mode

AP 3702i - IOS version for Autonomous Mode - Cisco Community

The device automatically triggers its fallback bootloader, requests an IP via a local broadcast sweep, and starts pulling the structured ap3g2-k9w7-tar.default data package over UDP Port 69 from your local server machine. 🔍 Verification and GUI Activation Troubleshooting : Denotes an Autonomous image

This technical guide covers how the naming structure functions, step-by-step conversion instructions, and troubleshooting steps for deployment problems. Deciphering the Firmware String

Deployment and Recovery using Ap3g2-k9w7-tar.153-3.jbb1.tar

A common use case is converting a controller-based "CAP" access point to a standalone "Autonomous" mode using this file. Cisco Community TFTP server : Indicates that this

ap: set IP_ADDR 10.0.0.5 ap: set NETMASK 255.0.0.0 ap: set DEFAULT_ROUTER 10.0.0.1 ap: set TFTP_SERVER 10.0.0.2 ap: flash_init ap: format flash: Use code with caution.

: The "k9w7" designation in the filename indicates it is an Autonomous (standalone) image. In contrast, "k9w8" images are for Lightweight mode, which requires a controller.

After conversion, if a DHCP server is present on the connected network, it will automatically assign an IP address to the AP. Use show interface bvi 1 in the console to find the assigned IP and access the GUI [S6].

The most common failure is the loop. You uploaded the autonomous TAR, but the AP keeps looking for a Wireless LAN Controller.