Hw 130 Motor Control Shield For Arduino Datasheet Better

The (often referred to as the L293D Motor Shield) is a popular, low-cost driver for small motors. It is based on two L293D motor driver ICs and a 74HC595 shift register to minimize the number of Arduino pins used. Key Specifications

The is a highly versatile, budget-friendly expansion board designed to drive multiple motors simultaneously. Based on the classic Adafruit Motor Shield v1 architecture, it integrates two L293D dual H-bridge driver chips and a 74HC595 shift register to unlock vast robotics capabilities while consuming minimal microcontroller I/O pins. hw 130 motor control shield for arduino datasheet better

Up to with 8-bit speed selection. Up to 2 stepper motors (unipolar or bipolar). The (often referred to as the L293D Motor

Here are the official and practical specifications for the HW-130 shield, as derived from its datasheet and community experience. Based on the classic Adafruit Motor Shield v1

achieves its high motor-density layout through a 3-chip architecture: and a 74HC595 8-bit Serial-to-Parallel Shift Register . Absolute Rating Recommended Operating Range Motor Supply Voltage ( Vmotorcap V sub m o t o r end-sub ) 4.5V to 36V DC 6V to 12V DC Logic Supply Voltage ( Vlogiccap V sub l o g i c end-sub ) 4.5V to 7V DC 5.0V DC (From Arduino) Continuous Current (Per Channel) 600 mA (0.6A) ≤is less than or equal to Peak Output Current (Non-Repetitive) Only for instantaneous start-up spikes Total Shield Max Power Dissipation 2.5W (At standard 25∘C25 raised to the composed with power C Kept lower unless heatsinks are added Hardware Pin Allocation Map

// --- Stop --- digitalWrite(IN1, LOW); digitalWrite(IN2, LOW); digitalWrite(IN3, LOW); digitalWrite(IN4, LOW); delay(1000);

Because many basic datasheets provided by manufacturers are sparse, cryptic, or poorly translated, this comprehensive guide serves as an upgraded, easy-to-read datasheet and technical reference manual. 🛠️ Technical Specifications