Achi Ir6500 Software Official

The original software suite for older firmware revisions. It is lightweight but lacks modern reporting templates.

Program, edit, and save specific thermal profiles (curves) for leaded and lead-free soldering.

: To prevent temperature overshoot, you can run an "Autotune" cycle (usually found in settings as 'ru' set to '1').

If you are struggling with the legacy factory software, the open-source community has developed far superior alternatives that offer modern UI enhancements and better operating system compatibility. BGA Rework Jet achi ir6500 software

Gradually raise the entire board temperature to 100°C–120°C.

The ACHI IR6500 relies on an internal programmable temperature controller (typically the PC410 or a similar Rex-C100 derivative) that communicates with a PC via a serial-to-USB interface.

: For lead-free solder, a typical reflow target is approximately 225°C to 245°C . The original software suite for older firmware revisions

Running the hardware without a programmed software profile risks blistering PCBs, delaminating substrates, or popcorn-damaging sensitive silicon chips. You must customize your software segments based on the alloy type. Recommended Lead-Free (Sn-Ag-Cu / SAC305) Profile

Look for "Ports (COM & LPT)." If you see a yellow exclamation mark, you need to manually install the driver. Step 2: Configure the COM Port

Select and "Run as Administrator." Best Practices for Successful Rework : To prevent temperature overshoot, you can run

How long the machine maintains the target temperature (measured in seconds).

This is the most common headache. If the software isn't "seeing" the machine: