Icom M700 Mods ~upd~ -

The IC-M700 has a rudimentary noise blanker that works poorly on most impulse noise (ignition, power lines). It effectively mutes the receiver rather than clipping the noise pulses.

Which you own (e.g., standard M700, M700PRO, or M710)

Route the HM-114 cord through the existing side hole and solder it to the new connector. icom m700 mods

After clipping the correct diode, ensure the clipped leads cannot touch any other components, reassemble the case, and perform a master CPU reset if required. The radio will now transmit anywhere it can receive. 2. Clarifier / RIT Modification

What is your comfort level with ? Share public link The IC-M700 has a rudimentary noise blanker that

Avoid using the front microphone jack for digital modes, as it introduces distortion from the mic preamp. Instead, tap into the accessory connections on the rear panel.

Because the IC-M700 lacks a modern computer control interface (CAT control), running digital modes requires creative hardware interfacing. Audio In/Out Connections After clipping the correct diode, ensure the clipped

If you want, I can: