917-front Audio Not Connected ((better)) Info

Troubleshooting Error 917: Front Audio Not Connected If you are staring at a black screen with the message "917-Front Audio Not Connected" every time you boot your computer, you are likely using an HP desktop

Alternatively, if your aftermarket case has loose single-pin connector wires, manually route the ground loop wire to the detection pin.

Locate the 10-pin header on your HP motherboard (it features a 5x2 pin layout with one missing key pin).

your computer entirely and unplug it from the wall. Open the side panel of the computer case.

If you recently installed a dedicated sound card and moved the front panel connector to that card, the motherboard's onboard sensor will trigger this error because it no longer "sees" the panel. Broken Components: 917-front audio not connected

Follow these methods in order from easiest to most advanced to resolve the error. 1. Check Internal Cable Connections

The most frequent cause of this error is a physically disconnected or loose internal cable.

The most common cause is a loose or disconnected cable inside your computer case. JustAnswer Power Down: Turn off your PC and unplug the power cord. Locate the Header:

Ensure your default playback device is set to your headphones/front speakers, not the rear port or HDMI. Step 2: BIOS/UEFI Configuration Troubleshooting Error 917: Front Audio Not Connected If

Before opening your PC, try these steps to rule out software issues.

Some proprietary systems let you disable specific hardware component monitoring directly within the BIOS menu.

Here is the step-by-step troubleshooting guide.

You moved an HP motherboard into a standard aftermarket PC case. Open the side panel of the computer case

Inside your computer case, the front audio panel connects to the motherboard via a small rectangular plug labeled .

The error is a standard Power-On Self-Test (POST) message that primarily targets pre-built desktop systems, most notably HP ProDesk, EliteDesk, and Compaq computers. This hardware warning alerts you that the motherboard cannot detect a proper electrical link to the chassis front audio panel.

To bypass this error without buying HP-specific parts, you must create a jumper bridge on the motherboard's audio header: