Ts1162 Installation Manual Exclusive Jun 2026
The Tecom TS1162 relies on standard binary DIP switches on the rear of the module to assign its hardware address and set network rules. Setting the RAS Address (Switches 1–4)
Position a drain trap in the hose approximately 8–10 inches from the unit.
Turn the master switch on. The LED indicator should flash amber, indicating "Setup Mode." ts1162 installation manual exclusive
Disclaimer: This article is an independent, exclusive technical guide compiled from field research and expert interviews. Always cross-reference with official safety guidelines. Improper installation may void warranties.
Remove the protective shipping plugs. Using a calibrated torque wrench set to only 5 Nm , attach a temporary coupler. Rotate the input shaft manually. Listen for at 120-degree intervals. These clicks confirm the internal cam follower is seated correctly. Silence or grinding means the unit has suffered shipping shock—do not proceed. The Tecom TS1162 relies on standard binary DIP
: Disconnect all AC and battery backup power from the main Challenger panel or Intelligent Access Controller (IAC) before handling wires.
Keep your TS1162 operating at peak efficiency by incorporating these simple preventative maintenance steps into your schedule: The LED indicator should flash amber, indicating "Setup Mode
Verify that the input has been properly mapped in the Challenger panel and that the mapping matches the physical terminal it was landed on. 🔗 Actionable Resources & Next Steps