Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Upd New!: Life Probo

Pull the cord firmly downward to disengage the internal locking pin. Slide the garage door manually up or down along its track.

The system requires a 230 Vac power line with adequate short-circuit protection and earthing. One-Touch Programming: Switch off the power supply.

Normally Closed (NC) input for safety STOP emergency systems. SECTION 6: CONTROL BOARD PROGRAMMING AND PROGRAM LEARNING Travel Limit Setup

Unscrew the four screws holding the omega-shaped support brackets to the base. Pull the cord firmly downward to disengage the

Unscrew the four hexagonal-headed screws holding the omega-shaped support brackets to release them.

Release the button and wait 10 seconds for the control board programming mode to time out automatically. Test the remote button to verify the door moves instantly. Page 9: Troubleshooting Guide and Error Codes Symptom / Error Probable Cause Actionable Solution No power supply or blown fuse

Wire the receiver contacts directly into the safety terminal loop. Obstruction Detection Test Place a 40mm tall solid object flat on the floor path. One-Touch Programming: Switch off the power supply

The Probo PR70 uses an integrated digital control board. Access the terminal blocks by removing the light cover. Connection Diagram Reference 24V DC Power Output for accessories. Terminals 3 & 4: Photocells (NC - Normally Closed contact).

Press the button on the control card briefly. An LED indicator will light up.

Hold the red button for 5 seconds to set obstacle sensitivity, with more LEDs representing higher sensitivity. 4. Maintenance Guide with more LEDs representing higher sensitivity.

Pin the front end of the rail into the header bracket using the long clevis pin. Lift the motor head up and support it on a ladder or hoist.

| Button | Press (Short) | Hold (3 sec) | |--------|---------------|---------------| | | On/Standby | Hard reset | | MODE | Cycle: Filter / Fan Speed / UV Purify | Enter settings | | SET | Confirm selection | Factory reset | | INFO | Show filter/UV life % | Show error log |

Connect the straight arm to the trolley and the curved arm to the door bracket.

is a premium, irreversible electromechanical gearmotor designed for residential garage doors. Engineered for sectional and spring counterbalanced up-and-over garage doors, the Probo PR70

Place a 50mm high solid object (like a wood block) flat on the floor under the center of the door path. Activate the close command via your remote.